KOUGER De-ntal Flexible Denture Machine 110V 400W Lab Equipment Electric hydraulic press Dentistry Injection System

Product description:

★ De-ntal flexible denture machine is a 400W/110V De-ntal laboratory equipment for making flexible removable partial dentures. .

★ The denture produced by the invisible denture injection molding machine has almost no waste edge, and the grinding process can be completed at one time.

★The denture injection system is easy to operate, has a long service life, low maintenance cost, high success rate, and De-ntal laboratory equipment for denture injection system, which is very necessary for dentists.

★ This machine is produced according to international standards. The operation is simple, time-saving, the casting success rate is high, and the common tooth box can also be injection molded.

★ The denture injection unit consists of a heater and a hot press. Heaters: temperature control, timers and electrical systems. Hot presses: frames, cylinders, heaters, brackets and flasks.

Features:

Voltage: AC 110V/60Hz

Power: 400 watts

Heating temperature: 282-288 ° C

Pressurization time: 7 minutes 30 seconds – 11 minutes

Packing size: 40*34*57cm

Gross weight: 30kg

The package includes:

1X heater

1X hot press

1X picking stick

1X small top bar

1X Big Top Bar

1X Type Box

1X box wrench

1X power cord

1Xproduct brochure

Steps:

1 The function of the heater is to heat the ink cartridge at a temperature of 282-288 ° C for about 7 minutes 30 seconds – 11 minutes to melt the flexible denture material in the ink cartridge.

2 The function of the hot press is to inject molten material into a previously prepared flask.

3 The heater will beep when it is heated.

Note:Please read the product manual carefully before operating the machine.

♛ BASIC INTRODUCTION – Den-tal Denture Denture Machine is a 400W/110V den-tal denture laboratory equipment used to make flexible removable partial dentures.
♛ HIGH PERFORMANCE AND HIGH EFFICIENCY – The denture injection system is easy to operate, has a long service life, low maintenance cost, and high success rate. The Den-tal laboratory equipment of the denture injection system is essential for dentists.
♛ SIMPLE OPERATION – simple operation, time-saving and high casting success rate. Ordinary gear boxes can also be injection molded.
♛ PRODUCT COMPOSITION – Den-tal denture injection device consists of heater and hot press. Heater: temperature control, timer and electrical system. Hot press: frame, roller, heater, bracket and flask.
♛ PACKAGE SIZE – 40*34*57cm (15.7×13.3×22.4 inches), gross weight: 30kg (66.1 pounds).